Lancia THESIS CONNECT Owner's Handbook Manual - page 53

52

The other recognition system set-

tings that can be enabled/disabled

are:

– automatic locking of doors and

boot.

As regards the setting of the recog-

nition system customizations, refer

to the CONNECT supplement.

FAILURE INDICATION

The presence of anomalies in the

Keyless System is indicated by the

lighting of symbol 

Y on the instru-

ment display, together with the mes-

sage “VEHICLE PROTECTION

SYSTEM FAULT”. 

IMPORTANT In case of fault, con-

tact your Lancia Dealership.

Before and during auto-

matic actuation of the

window regulators and

sunroof, always make sure that

the passengers and the persons

standing near the car are not

exposed to the risk of injures that

may be caused either by the mov-

ing windows and sunroof or by

objects dragged or hit by the

same.

To actuate central opening of the

windows and sunroof, keep the

remote control button B (fig. 25)

depressed for more than 2 seconds

after opening the doors: both the win-

dow regulators and the sunroof will be

actuated until they are fully opened or

until the button is released.

This function can be used to aerate

the passenger’s compartment before

getting into the car parked in the sun.

IMPORTANT Do not lay the CID

device outside the car on the sunroof,

to avoid a fake identification of the

CID itself as if inside the car. It is rec-

ommend to carry about with you the

CID device (e.g. into a pocket). 

SYSTEM SETTINGS

The CONNECT enables to cus-

tomize certain functions of the

Keyless System recognition system,

through the settings that can be

selected on the CONNECT display.

The “central unlock” and “driver’s

door unlock” functions of the central

locking can be set also for the

Keyless System and operate as fol-

lows:

– central unlock: all the car doors

are unlocked simultaneously and

access is possible through every door

– driver’s door unlock: access is

possible through the driver’s door

whereas the other doors remain

locked, thus preventing un-autho-

rized persons from getting into the

car. In this case, the led on the dri-

ver’s door panel lights up (green

colour) whereas the leds on the other

doors remain off.

When “unlocking driver’s door” is

set, it is anyhow possible to unlock all

the doors, to enable access to passen-

gers, by pushing button B (fig. 18) on

CID device or, after opening the dri-

ver’s door, by pushing the central

unlock button existing on the door

panel.