Lancia THESIS CONNECT Owner's Handbook Manual - 307

307

WITH AN ARM HOIST OR A

SHOP JACK 

The car can only be jacked up by

positioning the jack arms or the shop

jack in the areas shown in fig. 84.

An incorrectly posi-

tioned jack may cause the

car to fall. Do not use the

jack to lift loads exceeding those

indicated on the label attached to

the jack itself.

Be very careful not to

squeeze the brake pipes,

the fuel pipes or the side

member ribbing.

fig. 84

L0A6026b

JACKING THE CAR

WITH THE JACK

See “If a tyre is punctured”, in this

chapter.

Please note:

– the jack weighs 2.100 kg;

– the jack requires no adjustments;

– the jack cannot be repaired. If it

breaks, it must be replaced with a

new jack.

The jack should only be

used to change a wheel on

the car for which it was

designed. It should not be put to

other uses or employed to raise

other models. Under no circum-

stances should it be used when

carrying out repairs under the

car.