Lancia THESIS CONNECT Owner's Handbook Manual - page 63

62

Control C (fig. 40)

5 - Lumbar support increase

6 - Lumbar support decrease

Control C (fig. 44)

9 - Lumbar support increase 

10 - Lumbar support decrease 

11 - Vertical support increase 

12 - Vertical support decrease.

HEATING (fig. 45)

To switch seat heating on, rotate

control E to one of positions “1”,

“2” or “3” corresponding to the dif-

ferent heating intensity levels. To

switch seat heating off, rotate con-

trol E to position “0”.

fig. 45

L0A0175b

STORING THE DRIVER’S SEAT

POSITIONS (fig. 46)

The system allows to store and

recall three different driver’s seat

positions and external rear view mir-

ror positions.

Seat position memorization also

includes the head restraint adjust-

ment in height, the position of the

external rear view mirrors and of the

steering wheel (only versions with

electric adjustment).

The seat, external rear view mirror

and steering wheel positions can

only be stored when the ignition key

is at MAR.

Adjust the position of the seat,

head restraint, external rear view

mirrors and steering wheel by means

of the relevant controls, then press

for about 3 seconds any of buttons

“1”, “2” or “3” each corresponding

to one stored position, until a confir-

mation beep is heard. 

When memorising the seat posi-

tions, also the head restraint, electric

rear view mirror and steering wheel

positions are memorised.

The previously stored position will

automatically be deleted when a new

position is stored under the same

button.

IMPORTANT Seat position mem-

orization does not include lumbar

adjustment and heating actuation.

Recalling stored positions

With the key in position MAR, any

stored position can be recalled by

briefly pressing the respective but-

ton “1”, “2” or “3”. The seat will

move automatically and stop in the

stored position.

fig. 46

L0A0152b