Lancia THESIS CONNECT Owner's Handbook Manual - page 64

63

Stored position are recalled only if

the required position is different

from the current one and is not pos-

sible when the car speed exceeds 10

km/h.

Seats can be moved only when the

ignition key is at MAR and, for

about 1 minute, also after removing

the key or turning it to STOP: dur-

ing this time, the external rear view

mirrors will not move, but when the

car is started again, they will be

automatically realigned together

with the seat position (see paragraph

“Automatic realignment of external

rear view mirrors”).

If stored seat position recalling is

still in course after this time has

elapsed, recalling will be concluded

in any case.

If the engine is started during the

recalling stage, seat moving will be

stopped; once this stage is over the

seat will return automatically to the

stored position.

IMPORTANT Pressing any of

memorisation or adjustment buttons

during the recalling stage, causes the

immediate stop of the seat (antipan-

ic mode).

Storing the “parking” position of

the external rear view mirror on

passenger side

You can achieve better visibility

during manoeuvres in reverse gear

(for instance, when parking the car)

by adjusting the external passenger

rear view mirror to a different posi-

tion from the one normally used.

This position can be stored by the

driver.

To store the position proceed as

follows:

– with the car stopped and the igni-

tion key at MAR, engage the reverse

gear;

– adjust the position of the external

passenger rear view mirror by means

of the respective controls so as to

obtain the optimum position for the

parking manoeuvre;

– press down for at least 3 seconds

any of buttons “1”, “2” or “3” (fig.

46) used to store/recall the seat posi-

tion;

– together with the “parking” posi-

tion of the external passenger side

rear view mirror, also the seat posi-

tion, the driver rear view mirror

position and the driving position of

the external passenger side rear view

mirror are stored.

A sound signal warns the driver

that the mirror position has been

stored.