NEC SL2100 Installation Manual - page 66
66 |
P a g e
Single BRI Unit
The same concept applies to Basic rate, with a single BRI unit to assign a Unit ID, Port number and
Channel Number to a Trunk Number in MyCalls. Unless multiple units are being used, the unit ID will
always be 0. The port number is always the same as the channel number.
With Basic Rate ISDN the Channel Numbers run sequentially from 0-7, channel 0 will be trunk 1,
channel 1 will be trunk 2 and so on.
SV8100 / SL Trunk
Number
Unit ID
Port
ISDN Channel
1
0
0
0
2
0
1
1
3
0
2
2
4
0
3
3
5
0
4
4
6
0
5
5
7
0
6
6
8
0
7
7
Single Analogue Unit
Assuming the trunk numbers run sequentially from 1-8 then the channel mapping would be configured
as follows.
SV8100 / SL Trunk
Number
Unit ID
Port
Channel
1
0
0
0
2
0
1
1
3
0
2
2
4
0
3
3
5
0
4
4
6
0
5
5
7
0
6
6
8
0
7
7
SIP Trunk Call Recording
In order to use channel mapping with SIP Trunk call recording, you must have SV8100 R4 software or
above installed on the SV8100. Slightly different to the way channel mapping works on ISDN recording,
when a call SIP call is made, the trunk number that the call is made on is stored in the Sense database.
MyCalls can then match calls using the trunk number is was made on. SIP calls always has a fixed
Unit ID of 129 that
can’t be changed. If many SIP trunks are connected to one call recording PC then
then unit ID will always be 129 and the Port and Channel will always be the same as the trunk number.
Some examples are shown below:
SV8100 / SL Trunk
Number
Unit ID
Port
Channel
1
129
1
1
2
129
2
2
50
129
50
50
51
129
51
51
140
129
140
140
141
129
141
141