NEC SL2100 Installation Manual - page 67
67 |
P a g e
Multiple Units
When using multiple units, the same concept applies to the Channel Mapping for each trunk on the
PBX. The only difference is each Call Recording unit must be given a unique ID, this would usually be
0, 1, 2, or 3 as applicable. By default each unit comes with unit ID 0. To check or change the CSID of
a unit, open the Calls application and from the Box Menu, select Device Options.
The Device drop down menu will allow you to select an individual call recording unit and set the ID for
the unit in the CSID box.
If the ID of a unit is changed, then you have to
‘Save and Reset’ when you click this button the call
recorder box is restarted. If any calls are being recorded whilst the box is restarted then the they will
not be available for playback.