Oce Arizona T220 User Manual - page 17

Safety Information |

10/16/03

1-5

What to do with Ink Spills on Surfaces

Observe precautions as noted above, then: 

a) Ventilate the area;

b) Contain the spill;

c) Cover with absorbent material;

d) Collect spilled absorbent material;

e) Place in a closed container;

f) Clean up residue with water (do not release to waterways or sewer);

g) Incinerate in a permitted hazardous waste incinerator.

What to do with Ink Spills on Persons

•

Eye contact: immediately flush eyes with large amounts of water. Get 

immediate medical attention.

•

Skin contact: flush skin with large amounts of water. If irritation persists, 

get medical attention.

•

Inhalation: remove person to fresh air. If not breathing, get immediate 

medical attention and give artificial respiration. If breathing is difficult, get 

immediate medical attention.

•

If swallowed: call a physician immediately. Only induce vomiting at the 

instructions of a physician. Never give anything by mouth to an 

unconscious person.

IR Heater

Two infared heaters mounted on the gantry are used to dry the ink during printing. Each 

heater has two 3kw elements. The printer uses 3 of the 4 possible elements thus 

providing a maximum of 9kw of heat. The carriage passes under the heater and has a 

protective cover that reflects heat. The heater operates automatically and does not 

require operator intervention.

Caution:

Keep hands clear of the heater assembly. This area will be hot during 

and right after printing.