Oce Arizona T220 User Manual - page 76
Océ | Media
5-64
3010100686-B
recommend that you group the desired image with a preceding image so the printer is a
consistent temperature when starting to print the desired image.
5.1.3
Media Holder Strips
Some media, such as Fome Cor, has a tendency to warp off the table when subjected to
heat. This warpage can result in a carriage collision. Media Holder Strips — which are
shipped with the printer — help to limit this possibility. Six strips may be required to
border the long edges of a sheet of 4'x8' Fome Cor.
The media holder strips are 1/8" (3.2mm) thick. When using media with the media
holder strips, 3/16" (4.8mm) thick material should be used.
Directions for use:
1.
Place the media on the table with a minimum offset of 2"(50mm).
2.
Turn on the vacuum.
3.
Mask off open vacuum zones with scrap pieces of media < the height of the media
printed on.
Figure 28 Sheet of Foam Cor with Media Hold-Down Strips
Note:
Thermal expansion may cause color-to-color alignment problems.
Important: Make sure you do not use any media less then this thickness.