Oce Arizona T220 User Manual - page 47
Printing a Job |
10/16/03
3-35
Press ACCEPT to move the carriage away from the capping station and thus allow
access to the Pre-Fire Stripe Catcher.
This turns off the interlock on the gantry doors and allows you to open them. Insert a
shim of equivalent media thickness or a piece of media itself into the slot on the catcher
assembly. This will set the appropriate height for the media.
Figure 12 Setting Media Thickness
After placing the shim in the catcher adjustment slot, close the gantry doors and press
ACCEPT to advance to the next step.
Press ACCEPT again to bring the carriage back to the capping station. The carriage will
then check the height and move to the Heater Setting option if the height is OK. If the
shim is too thick in relation to the current thickness setting, the control panel displays an
error message and then prompts you to re-adjust the catcher.
Note:
If the shim is too thin, there is no error message displayed. However this may
result in a thin mist of ink that could accumulate on the nozzle plate and
affect performance.
Print Mode
speed 1x
Pre-Fire Stripe Catcher Adjustment
Step 2: Open door and adjust catcher
Print Mode
speed 1x
Pre-Fire Stripe Catcher Adjustment
Step 3: ‘ACCEPT” to park the carriage