Oce Arizona T220 User Manual - Cleaning Solution Usage
Océ | Printer Maintenance
7-78
3010100686-B
7.1.3
Cleaning Solution Usage
The cleaning solution, CGS 80, part #3000-0057, is a solvent used to flush print heads
and clean ink from surfaces with a lint-free cloth. Ink stains on painted sheet metal
should NOT be exposed to the cleaning solution as it will cause the paint finish to smear.
Use isoprophyl alcohol to clear ink on painted surfaces.
The cleaning solution is also used to supply and preserve the capping station foam pads
during operation of the printer. The operator replaces or refills the cleaning solution
container located on the ink supply tray when the printer senses the bottle is nearing
empty.
Cleaning ink buildup from the capping station, carriage face plate, and the print head
nozzle plate help to ensure optimum performance from your Arizona T220 printer .
Cleaning should be done once a week or as required before media placement and large
print runs.
7.1.4
Recommended Maintenance Frequencies
Table 4 Arizona T220 Printer Operator Maintenance Schedule Guidelines
Description
Location in Manual
Frequency
Pre-fire Stripe Catcher
“Cleaning the Pre-fire Stripe Catcher” on page 80
Daily
Swabbing Print Heads
“Swabbing Printheads” on page 81
Weekly, or as
required
Remove Ink from Table
“Removing Ink From the Table” on page 79
As required
Carriage Underside
“Carriage Underside” on page 83
Weekly
Capping Station
“Capping Station” on page 84
Weekly
Foam Pads
“Foam Pads” on page 84
Weekly
Gantry Rails
“Clean Gantry Rails” on page 86
Monthly
Air Filter
“Air Filter (Electronics Enclosure)” on page 88
Every 6 months
Coalescing Filter
“Coalescing Filter” on page 87
Every 6 months
Linear Encoders
“Linear Encoders (Table and Gantry)” on page 88
Every 6 months