Oce Arizona T220 User Manual - page 49
Printing a Job |
10/16/03
3-37
Changing Horizontal and Vertical Offsets
This display allows you to change first the horizontal and then the vertical offsets.
Use the ACCEPT key to move through the displayed digits. The selected digit has an
underline indicating it can be increased or decreased using the + or - keys. When the digit
you want to use is displayed, press ACCEPT and the underline moves to the next digit.
When you are at the last digit, pressing ACCEPT advances to the Place Media display.
Place Media Menu
The menu now displays the following pre-print message:
Press ACCEPT and the gantry will move to position itself over the media. Printing does
not start immediately as there are some warmup procedures to follow first, including
applying heat from the lamps to warm up the media.
When printing begins, the image start point is the lower left corner of the image.
Figure 13 T220 Printing Direction and Offsets
Print Mode
speed 1x
Enter new H offset: (-6 to 2783mm)
H: +04.00mm, V: +0755mm
Print Mode
speed 1x
Place media on table. Turn vacuum ON.
Press ACCEPT to start printing
Ve
rtic
al
off
se
t
Horizo
ntal off
set