Oceanic VEO 3.0 Operating Manual - page 32

32

Set F Lead-in, information includes (Fig. 15):

>  Graphics SEt and F

•  A (< 2 sec) to step forward to Set A Lead-in.

•  M (< 2 sec) to step back to Log Lead-in.

•  S (< 2 sec) to access Set FO2 Gas 1.

Set FO2 Gas 1, information includes (Fig. 16A, B):

>  Graphic SEt if Air; or Max Depth allowed for the PO2 

alarm set with FT (or M) and NX icons if Nitrox

>  Gas 1 (tank) icon

>  PO2 alarm value set (ATA) with PO2 and MAX icons, blank 

if Air

>  Graphic Air, or numeric FO2 Set Point value if Nitrox, 

flashing, with FO2 icon

•  A (hold) to scroll upward through Set Points at a rate of 

8 per second from Air (default) to 21 through 100 (%) in 

increments of 1%.

>  The scroll will stop when A is released, or at 32, 50, and 80% (even if A 

is held depressed).  Pressing and holding A again will resume the scroll 

through 100, then stop at Air or 21%.

•  A (< 2 sec) to step upward through Set Points one at a time.

•  M (< 2 sec) to step back through Set Points one at a time.

•  S (< 2 sec) to save the setting and access Set FO2 Gas 2.

•  S (2 sec) to revert to Set F Lead-in.

Fig. 16A - SET FO2 GAS 1

Fig. 16B - SET FO2 GAS 1

Fig. 15 - SET F LEAD-IN