Oceanic VEO 3.0 Operating Manual - page 98

98

Fig. 116  - BATTERY

Fig. 117 - RETAINING BAR

Battery Installation

•  Slide a new 3 volt type CR2450 Lithium Battery, ( - )

negative side down into the Battery Compartment.  Slide 

it in from the right side and ensure that it slides under the 

contact clip on the left rim (Fig. 116). 

•  Orient the Retaining Bar across the lower portion of the 

Battery and carefully push it down into position (Fig. 117).   

Battery Cover and Retaining Ring Installation

•  Lightly lubricate a new Cover O-ring* with silicone grease  

and place it on the inner rim of the Battery Cover (Fig. 

118).  Ensure that it is evenly seated.

*The O-ring must be a genuine Oceanic part that can be purchased from an 

Authorized Oceanic Dealer.  Use of any other O-ring will void the warranty. 

•  Slide the Cover Ring, top portion first (small opening), onto 

your thumb.

•  Carefully place the Battery Cover (with O-ring) into position 

on the rim of the Battery Compartment, then press it evenly 

and completely down into place with your same thumb.

• Maintain the Battery Cover securely in place and, using 

your other hand, slide the Cover Ring down off your thumb 

and into position around the Battery Compartment.  

•  The tabs on the Cover Ring fit down into the two slots 

located at the 2 and 8 o'clock positions.  

Fig. 118  - COVER O-RING