Oceanic VEO 3.0 Operating Manual - page 99

99

•  Using your fingers, turn the Ring counter clockwise 5 

degrees until the tabs engage (Fig. 119), then tighten it 5 

more degrees by turning it counter clockwise with the aide 

of a small blade screwdriver (Fig. 120).  

•  While tightening the Retaining Ring, exert continuous 

inward pressure on it until it is secured in the proper 

position.  A small symbol located on the Ring should be 

aligned with the Locked symbol located on the Housing 

(Fig. 121a) 

Inspection

•  Activate the unit and watch carefully as it performs a full 

diagnostic and battery check, and enters Surface Mode.

•  Observe the LCD display to ensure it is consistently clear 

and sharp in contrast throughout the screen.

WARNING:  If there are any portions of the 

display missing or appearing dim, or if a Low 

Battery condition is indicated, return the unit to 

an Authorized Oceanic Dealer for a complete 

evaluation before attempting to use it.

Fig. 119  - TABS ENGAGE

Fig. 120  - TABS TIGHT

Fig. 121  - RING SECURE

a