Oceanic VEO 3.0 Operating Manual - page 82

82

Fig. 94 - CDT STATUS

(On, running)

CDT Lead-in, information includes (Fig. 93):

>  Graphics Cdt and FRE

•  A (< 2 sec) to step forward to Set FA Lead-in.

•  M (< 2 sec) to step back to ALT 2.

•  S (< 2 sec) to access CDT Status.

CDT Status, information includes (Fig. 94):

>  Countdown Time (min:sec) remaining or set/ready to start, 

0:00 if complete

>  Graphics CDT - with OFF (or ON) flashing

•  A (< 2 sec) to step up through OFF, ON, SEt (Fig. 95).

•  M (< 2 sec) to step back through OFF, ON, SEt.

•  S (< 2 sec) to save the setting.

>> If On is saved and a CDT was set, the CDT will start 

counting down and operation will revert to the Lead-in.

>> If Off is saved, the Timer will stop counting down and 

operation will revert to the Lead-in.

>> If Set is saved, the Set CDT screen will be displayed.

•  S (2 sec) to revert to CDT Lead-in.

The CDT will run in the background, while on the surface and 

during dives, until it counts down to 0:00, or it is turned OFF.

Fig. 93 - CDT LEAD-IN