Oceanic VEO 3.0 Operating Manual - page 48
48
CLEAR (RESET)
The VEO is configured with a feature that allows data to be
cleared, including nitrogen and oxygen calculations and Log
entries. This is intended for facilities using the VEO for rental or
training activities, not for general use by individual divers.
WARNING: Reset after a dive and subsequent
use for a repetitive dive conducted by the same
diver could result in serious injury or death.
Upon access, a factory assigned code number is displayed with
the graphics CLR and id, all solid (Fig. 45).
Reset procedure:
• S (2 sec), at any time, to cancel the procedure and revert to the SN screen.
• S (< 2 sec) to start the first 2 digits (left) flashing.
• A (hold) to scroll upward through the first digits (left) at a rate of 8 per second.
• A (< 2 sec) to step upward through the digits (left) one at a time.
• M (< 2 sec) to step back through the digits (left) one at a time.
• S (< 2 sec) to save the first 2 digits (left) and the second 2 digits (right) shall flash.
• A (hold) to scroll upward through the second digits (right) at a rate of 8 per second.
• A (< 2 sec) to step upward through the digits (right) one at a time.
• M (< 2 sec) to step back through the digits (right) one at a time.
• S (< 2 sec) to save the reset code, clear the unit, and turn it Off.
Fig. 45 - CLEAR