Saeco Cappuccino Service Manual - page 38
3. OPERATION
ROYAL
20/25
REV.4 SEPT.2003
Saeco International Group
Cleaning
Empty dregs drawer
Storage capacity of 30 tablespoons (dreg counter reset only if warning
to empty grounds container is triggered and machine is turned on).
Empty drip tray
With dregs drawer
Clean water tank.
As required
Clean coffee bean container.
As required
Clean the housing.
As required
Rinse brewing unit
1 x per week
Clean brewing unit and
lubricate
Clean filter
1 x per month
Descale
According to indicator
Descale:
1. Place Saeco descaler into fresh water tank.
2. Fill with about one litre of hot water.
3. Remove about two to three cups via the brewing unit.
4. Confirm the Descale item in the user menu by pressing twice the E-button (place a
sufficiently large container under the hot water pipe). The descaler mixture is pumped at
intervals through the circuit.
5. Rinse: Fill the water tank once again and press the E-button twice (about 2 cups via
brewing unit).
Reset:
Under the descale indicator item Enter - YES - Enter.
Troubleshooting
Fault/Indicator
Possible cause
Remedy
Does not function
No power
Check mains plug / mains
circuit breaker /
Ensure machine door is
closed.
BREWING UNIT NOT
DETECTED
Brewing unit not properly installed
or not closed.
Install brewing unit correctly.
GRINDS CONTAINER NOT
DETECTED
Coffee grinds container not properly
installed.
Brewing unit correctly
installed.
COFFEE BEAN
CONTAINER EMPTY
Coffee bean container is empty.
Fill coffee container.
Reset: Enter button
FILL WATER
DE-AERATE
Water tank is empty.
Water tank
OVERHEATING
After steam dispensing the system is
not or is insufficiently de-aerated.
De-aerate machine.
GRINDER OBSTRUCTED
Clean grinder.
DE-AERATE
Air in water system.
Press hot water button.
Instead of coffee, only water is
dispensed.
Coffee powder selection button is
pressed, but no coffee powder is
dispensed.
Add one level measure of
coffee powder.
No water / steam
Steam nozzle blocked.
Free opening using a thin
needle.
Attention:
The coffee beans low indicator must be reset (
keep the enter button pressed for a
minimum of 5 sec.
).