Vela 2000-0422 Installation And User Manual - page 139
Manual is about: MPEG-2 Four-Channel Serial Digital Interface (SDI) A/V Decoder System for Broadcasters
of
196
Chapter 2 — Overview and Operation
125
START STOP UNIT (OpCode 0x1B, 6 bytes)
START STOP UNIT (OpCode 0x1B, 6 bytes)
This command does not currently affect decoder operation — only Good status is
returned. Format of command:
TEST UNIT READY (OpCode 0x00, 6 bytes)
The
TEST
UNIT
READY
command always returns Good status, except after power-
up, SCSI Reset, or Bus Device Reset. Command format:
Immed
Immediate is Ignored
LoEj
Load Eject is Ignored
Start
Start Bit is Ignored
Table 2-28.START STOP UNIT Command Format
Table 2-29.TEST UNIT READY Command Format