Vela 2000-0422 Installation And User Manual - page 34
20
CineCast Quad Pro Version 2.6 Installation and User Manual
Software Installation
screen will appear (Figure 1-1).
• From the Autorun screen, select the “Explore This CD” option. A screen
similar to that in Figure 1-2 will appear.
• Double-click on the System folder.
• Double-click on the “NT Service Pack” folder.
• Double-click on the sp6i386.exe file.
• The application will extract files, then ask you to read a license agreement.
After reading the agreement, check the “Accept License Agreement”
checkbox as well as the “Backup Files Required to Uninstall” checkbox.
• Click Install.
• Click Next, OK, or Finished to all of the screens that follow.
• If you are asked to reboot, allow the system to restart before continuing.
3. The Autorun setup screen (Figure 1-1) should appear after the reboot. If it
does not, use Windows Explorer to select and run setup.exe from the CD-ROM.
4. Install Internet Explorer version 5, Service Pack 4 or later, if it's not already
installed on your system. Again, you can download this from the Internet, or
you can install it from the Vela system software installation CD-ROM. To use
the CD-ROM, follow these steps:
• Insert the CD-ROM disc into the CD-ROM drive.
• When the setup screen appears, select the “Explore This CD” option.
• Double-click on the “System” folder.
• Double-click on the “MSIE5 NT” folder.
• Double-click on the setup.exe icon. When a window pops up to select
“Typical” or “Minimal” Installation, select “Minimal.”
• On the next screen, deselect (remove the checks from) the “Windows Media
Player” and “Outlook Express” selections.
• The version of Windows Media Player included with Internet Explorer 5.0 is
outdated. A more recent version is included on this CD, though the installa-
tion of Windows Media Player and Outlook Express are not a requirement
for the CineCast Quad Pro.
• Click Next, OK, or Finished to all of the screens that follow.
• If you are asked to reboot, allow the system to restart before continuing.
5. The setup screen should appear after the reboot. If it does not, use Windows