WEG CFW-11 User Manual - page 23
Installation and Connection
3
3-2 | CFW-11
3.1.2 Mounting Considerations
Consult the inverter weight at the
.
Mount the inverter in the upright position on a flat and vertical surface.
External dimensions and fixing holes position according to the
. Refer to the
8.5 MECHANICAL DATA on page 8-9
First put the screws on the surface where the inverter will be installed, install the inverter and then tighten the screws.
Minimum mounting clearances requirements for proper cooling air circulation are specified in
.
Do not install heat sensitive components right above the inverter.
ATTENTION!
When arranging two or more inverters vertically, respect the minimum clearance A + B (
) and provide an air deflecting plate so that the heat rising up from the bottom inverter
does not affect the top inverter.
ATTENTION!
Provide conduit for physical separation of the signal, control, and power conductors (refer to