Yamaha M7CL StageMix V1.5 Quick Start Manual - To Apply Recall Safes;
7
M7CL Quick Start Guide Part 3
To apply Recall Safes;
The Recall Safe pop-up is in the Channel Job area. Press the CH JOB area on the screen and then select RECALL
SAFE, the pop-up will appear.
Recall Safes can be applied from this screen and the
Safe Parameters can be selected.
To apply a Safe, select the channel to display its setting
in the lower part of the pop-up. Select the parameters
to be safed (eg ALL or HA and EQ). Turn on the Safe
with the SAFE button. This setting can be applied to
many channels quickly by using the SET BY SEL function
in the box above.
Channels with all parameters safed are shown green.
Channels with partial safes are shown blue. There are
many possible partial safe combinations but all are
shown in blue.
Turning safes on and off.
Safes can be turned on and off from the Selected
Channel View and there is also a short-cut to the RECALL
SAFE MODE pop-up. If the safe is set to a partial setting
this will be indicated here and the partial setting
remains even when switched off.
It is easy to create mute scenes by selecting all the buttons other than CH ON from the SAFE PARAMETER SELECT
part of the RECALL SAFE MODE pop-up, and applying this to all channels. In this case each scene will only operate
the channel ON/OFF parameter. Check to Safe all the RACK, NAME and PATCH boxes too.
Note;
Note;
There is a difference between [ALL] and all the parameters buttons together. Be aware of the exception
that channel link, MIX/MATRIX bus setup, TO STEREO/MONO, PAN/BAL, LCR, and MUTE/DCA Assign are also
recalled with ON/OFF keys, because these parameters are not subject to recall safe (always recalled) or can be
safed only with ALL. For a more in-depth understanding of Recall Safe consult the “M7CLV3 Recall Safe Guide”
available from the Self Training pages of www.yamahapraudio.com