Yamaha RY20 Owner's Manual - page 116
108
Changing the Effects
In this mode, you can adjust the right and left channel delays.
1
Select the Delay Time display page by pressing the
[ PAGE+ ]
or
[ PAGE– ]
button. The current levels are displayed under the “
D.TIME
” prompt with
the left channel level flashing.
2
Set the left channel delay time by rotating the Jog Dial or by using the
[ +1 ]
and
[ –1 ]
buttons.
For the delays “
DELY1
” and “
DELY2
”, the range is “
00
” to “
99
”. These
settings change the length of the delay loop for each channel. A low value
sets a short loop while a high value sets a long loop.
The other two delays, “
DELY3
” and “
DELY4
”, use synchronized delays:
3
Change the focus to the right channel delay time by pressing the
[ > ]
cursor button. Set its value by rotating the Jog Dial or by using the
[ +1 ]
and
[ –1 ]
buttons.
■
Delay Time
NOTE
As with feedback gain, the delay time setting can only be applied to the delay
effects. When the reverberation effects are selected, “
-- --
” is displayed.
T0
Sets a 32nd note triplet delay.
T1
Sets a 32nd note delay.
T2
Sets a 16th note triplet delay.
T3
Sets a 16th note delay.
T4
Sets an eighth note triplet delay.
T5
Sets an eighth note delay.
PAGE –
PAGE +
PATTERN
EFFECT
A CHASE
DRUM KIT
MAIN A
PAD BANK
OTHERS
HH
SD
BD
3
3
3