Yamaha RY20 Owner's Manual - page 135
127
The following is a list of messages that the RY20 will display if errors or other conditions have
occurred.
■
LCD Messages
PRESET
You have attempted to change a parameter in a preset pattern, song or drum kit.
MEMORY
FULL
The RY20 memory is full or almost full and the specified operation cannot be performed.
Delete unwanted songs to make more memory available.
SELECT
TRACK
You have attempted to copy or clear a pattern without first selecting tracks. Select tracks
and try the operation again.
PART
EMPTY
You have attempted to delete a part in Song Record Mode that was already empty.
NOT
EMPTY
You have attempted to change the meter or number of measures in a pattern which
contains data. Clear the pattern and try again.
TS NOT
MATCH
You have attempted to copy tracks to a pattern that has a time signature different from
that of the source pattern.
BUFFER
FULL
Too much MIDI data is being received by the RY20 at one time. Reduce the amount of data
that is being sent to the RY20.
BATT
LOW
The built-in memory back-up lithium battery is running low. Take your RY20 to an
authorized Yamaha Service Center to have the battery replaced.
DO NOT ATTEMPT TO REPLACE THE BACK-UP BATTERY YOURSELF.
DATA
ERROR
Unrecognizable MIDI data was received by the RY20. Make sure that all bulk data sent
to the RY20 conforms with the RY20 MIDI specifications.
TIME
OVER
If a MIDI bulk data transfer fails to complete within a certain period of time, this error
message will appear on the display.
MIDI
ERR1
The RY20 detected a MIDI overrun error in the incoming data. Check all relevant settings,
then try sending the data again. If the error persists, check your MIDI cables and
connections.
MIDI
ERR2
The RY20 detected a MIDI framing error in the incoming data. Check all relevant settings,
then try sending the data again. If the error persists, check your MIDI cables and
connections.
PLEASE
WAIT
The RY20 is busy performing the requested operation, for example, preparing to record,
rearranging its memory to complete a recording, etc.
END
The RY20 has just completed the requested operation, for example, finishing a recording,
copying data, sending or receiving MIDI bulk data, etc.
BULK
SEND
The RY20 is transmitting MIDI bulk data to an external device.
RECEIV
BULK
The RY20 is receiving MIDI bulk data from a MIDI data storage device.