3Com 3C16685 User Manual - page 101
Accessing a Different Hub or Stack
101
could indicate that there is faulty equipment somewhere on the
network, or that the network is badly configured.
Accessing a Different Hub or Stack
If a different type of unit or stack is connected to the Dual Speed
Hub 500 stack with a Cascade Converter Kit, you can access its
management screens from the Dual Speed Hub 500 web interface.
Management software agent version 1.20 (shipped with the Cascade
Converter Kit) or later must be installed on the Dual Speed Hub 500.
For information on upgrading, refer to
“Software Upgrade”
on
page 99
.
Using the Dual Speed Hub 500 – Hub 10 Cascade Converter Kit, you
can connect a managed Hub 10 unit or stack to the Dual Speed
Hub 500 stack. For more information, refer to
“Management of a
Different Hub or Stack”
on
page 17
.
To access the management screens of the attached stack:
1 Click on the Cascade Module icon that is below the stack icon on the
side bar of the web interface, as shown in
Figure 24
.
Figure 24 Cascade Module Icon
The Cascade Module icon does not reflect the number of units in the
attached stack. When you connect the unit or stack to the Dual
Speed Hub stack, it may take 30 seconds to register the connection.
If the Cascade Module icon is not present, you may need to reload
the web interface page at your Web browser.
The web interface changes to show the Cascade Module Attached
Unit(s) page, as shown in
Figure 25
. The management categories on
the side bar are inactive except for the stack icon, which returns you