3Com 3C16685 User Manual - page 70
70
C
HAPTER
3: U
SING
THE
C
OMMAND
L
INE
I
NTERFACE
A power interrupt during the software upgrade may cause a
corrupted agent image on the hub. If this occurs then subsequent
rebooting of the unit will be unsuccessful and the power LED will
flash. In this event the software should be updated using the
“Serial
Update Utility”
. See
Appendix D
on
page 127
for details.
Displaying and Changing SNMP-related Information
You can display and change SNMP-related information for the stack
using the commands on the SNMP menu. These commands allow
you to:
■
Specify SNMP community strings for the stack
■
Specify the trap destination details for the stack
■
Display the trap destination details for the stack
■
Modify trap destination details for the stack
■
Remove trap destination details for the stack
■
Perform an SNMP GET instruction on the stack
■
Perform an SNMP GETNEXT instruction on the stack
■
Perform an SNMP SET instruction on the stack
Specifying SNMP Community Strings
You can specify SNMP community strings for the users defined on
the stack using the
community
command on the SNMP menu.
To specify the SNMP community strings:
1 At the Top-level menu, enter:
snmp community
The following prompt is displayed:
Enter new community for user ‘
2 Enter the community string for the user.
3 Repeat step 2 for the other users defined on the stack.
Specifying Trap Destination Details
You can specify the community string and IP address of devices that
are to be the destination for traps on your network using the
define
command on the SNMP/Trap menu.
To specify the details of a trap destination device:
1 At the Top-level menu, enter: