3Com 3C16685 User Manual - Unit Status
84
C
HAPTER
4: U
SING
THE
W
EB
I
NTERFACE
Identifying Which Ports Belong to a Segment
To view which ports belong to a segment, click on the 10Mbps or
100Mbps segment buttons on the Unit View. The graphic changes
and ports that are members of that segment are highlighted with a
dark blue surround.
Unit Status
This page provides detailed information about the unit:
System Name The name configured for the stack.
Location Where the stack is located.
Contact The person to contact if there is a problem with the stack.
The System Name can be configured using the System Name page (in
the Management Settings category), refer to
“System Name”
on
page 94
. The Location and Contact can be configured using an
SNMP network management application.
Unit Description The unit’s product name.
Hardware Rev The version of hardware inside the unit.
MAC Address The unit’s MAC (Ethernet) address.
Software Version The version of management software that the
unit is running.
Boot PROM Version The version of software on the Boot PROM
inside the unit.
Product Number Displays the 3Com product number of the unit.
TFTP Server (optionally displayed) Displays the IP address of the
last TFTP server used to upgrade the unit’s management software.
Filename (optionally displayed) Displays the name of the
management software file that was used during the last software
upgrade attempt.
Software Upgrade Status (optionally displayed) Displays the
reason for a software upgrade failure.
Unit Uptime The time that has elapsed since the unit was last reset,
initialized or powered on.
Unit Attention Light Causes the unit’s Mgmt/Attn LED to flash. You
can use this LED to help identify the unit in the stack.