3Com 3C16685 User Manual - page 51
Commands
51
Configuring the Unit’s IP Information
Before you can manage the unit or stack over the network, you must
assign it an IP address and subnet mask. You may also need to enter
a default gateway (sometimes known as the default router) address.
The default router is the router (if you have one) that is used by the
stack to communicate with other networks. For serial management,
you may need to configure the SLIP address and SLIP subnet mask.
If you have no previous knowledge of IP, refer to
“IP Addresses”
on
page 30
. If you change any of these values, you may need to
re-access the hub using the new values.
The IP information is stored in the unit but can be used to access the
whole stack.
If you enable BOOTP for the unit and there is a BOOTP server on your
network, the server can automatically allocate an IP address, subnet
mask and default router address to the unit. For information on how
to use your BOOTP server, refer to the documentation that
accompanies it.
Configuring the IP Information
To enter new IP settings:
1 At the top-level menu, enter:
ip interface define
2 You are prompted for the unit’s IP address:
Enter IP address [0.0.0.0]:
Enter a valid IP address for the unit.
3 You are prompted for the unit’s subnet mask:
Enter subnet mask [255.255.255.0]:
Enter a subnet mask.
4 You are prompted for a default router address:
Enter default gateway [0.0.0.0]:
Enter a default gateway address or press Return if it is not required.
5 You are prompted for a SLIP address:
Enter SLIP address [192.168.101.1]: