3Com 3C16685 User Manual - page 50
50
C
HAPTER
3: U
SING
THE
C
OMMAND
L
INE
I
NTERFACE
The following prompt is displayed:
Enter access level (monitor,manager,security):
2 Enter the access level to be modified. The following prompt is
displayed:
Enter new value for SNMP (enable,disable) [enable]:
3 Enter
enable
if the access level allows SNMP management, or
disable
if it does not. The following prompt is displayed:
Enter new value for console (enable,disable) [enable]:
4 Enter
enable
if the access level allows management through a
console port of the stack, or
disable
if it does not. The following
prompt is displayed:
Enter new value for telnet (enable,disable) [enable]:
5 Enter
enable
if the access level allows telnet management, or
disable
if it does not. The following prompt is displayed:
Enter new value for web (enable,disable) [enable]:
Enter
enable
if the access level allows web management, or
disable
if it does not.
Configuring Another Unit in the Stack
Many commands in the command line interface perform actions on a
specific unit in the stack (the unit you are managing). You can move
the focus of the command line interface to another unit easily.
To configure another unit in the stack:
1 At the top-level menu, enter:
system unit
You are prompted for the unit’s number:
Select unit:
2 Enter the unit’s number.
If the stack is correctly connected and configured as recommended,
the bottom unit in the stack is unit number 1, the next unit is unit
number 2, and so on.
When you have finished configuring the unit, simply log out to
return to the previous unit.