3Com 3C16685 User Manual - page 63
Commands
63
of these packets and examine the transceiver or adapter card at
the device. Some protocols may generate these packets.
■
Fragments
— The total number of packets received that were
not an integral number of octets in length or that had a bad
Frame Check Sequence (FCS), and were less than 64 octets in
length (excluding framing bits but including FCS octets).
■
Jabbers
— The total number of packets received on this
segment that were longer than 8,000 octets (excluding framing
bits, but including FCS octets). Jabber is the uncontrolled
transmission of oversized packets to the network by a faulty
device.
■
Collisions
— An estimate of the total number of collisions
that occurred when transmitting on the segment.
Displaying Ethernet Segment Summary Information
You can use the
summary
command to display summary
information about a single Ethernet segment or all segments on a
Hub since last reset. From the Top-level menu enter:
ethernet segment summary
The command line interface shows a screen of information similar to
the following:
The statistics that are displayed are accumulated over the time
interval since the last reset, initialization or power-off/on cycle. The
Errors (Total)
statistic is the sum of the following errors:
■
FCS Alignment Errors
■
Undersized Packets
■
Oversized Packets
■
Fragments
■
Jabbers