3Com 3C16685 User Manual - page 102
102
C
HAPTER
4: U
SING
THE
W
EB
I
NTERFACE
to the Dual Speed Hub 500 web interface when one of the units in
the icon is clicked.
Figure 25 Cascade Module Attached Unit(s) Page
2 In the IP Address field, specify the IP address of the attached stack
(for example a Hub 10 stack) and click Launch Telnet Session. The
specified IP address is remembered by the Dual Speed Hub 500 and is
displayed in the IP Address field for future management sessions.
Remember that:
■
If you enter an IP address of ‘0.0.0.0’, you get an error.
■
If you change the IP address of the attached stack, you must
re-enter the new IP address in the Cascade Module Attached
Unit(s) page when starting the next management session.
■
If you enter the wrong IP address, the web interface fails to find
the attached stack and may display the management screens for
a different device on your network (that has the IP address you
entered).
If your Web browser has been configured to start a Telnet
application, the web interface starts the Telnet application and passes
the IP address to it. When the attached stack is found, its
management interface is displayed in the Telnet application, and you
are now ready to manage the unit or stack. Refer to the
documentation that accompanies the attached stack (or its
management module) for information on using its management
interface.
If your Web browser has not been configured to start a Telnet
application, a message appears asking you to pick a suitable
application to view the management interface. Browse for a Telnet
application. To configure your Web browser to start a Telnet
application for future management sessions, refer to
“Configuring
Your Browser”
on
page 103
.