D-Link DES-2108 User manual - Static Mac

Modify Trap: To modify previously defined SNMP Trap, click on 

the ID parameter to enter to the selected SNMP Trap to configure its 

community name, IP address and events. Press “Apply” to save 

change of the SNMP Trap. 

Figure 34.   Modify SNMP Trap 

Static MAC 

The Static MAC function allows you to enable the Switch to forward 

the data packets to specific MAC address and specific port. Only 

Static MAC function enabled ports will follow the Static MAC rule 

from the Static MAC list.  

Enabled / Disabled: Selecting the enable or disable Static MAC 

function on the Switch. Select “Enabled” to enabling the Static MAC 

function on the Switch, the Switch’s auto learning function will be 

disable except the specific port (set in the “Disable auto learning 

excluding uplink port” setting), and the Switch will forward data 

following the Static MAC Address Table to the specific port. Select 

“Disabled”, the Switch will learn and build MAC address table 

42