DAELIM BESBI SC125 - Service Manual - page 151
14-5
BRAKE SYSTEM
INSPECTION
Check the caliper cylinder bore for scoring, scratches
or other damage.
Measure the inner diamater of caliper.
SERVICE LIMIT:27.06
m
Check the caliper piston outer diameter part for
scratches or other damage.
Measure the out diamater of piston.
SERVICE LIMIT:26.91
m
ASSEMBLY
Clean the piston seal and the dust seal with the brake
fluid and install them in the caliper. Install the piston in
the caliper with the groove side of the piston facing the
pad.
NOTE
Make sure that each part is free from dust or dirt
before reassembly.
Replace the dust seals and piston seals as a set
whenever they are removed.
When cleaning with the brake fluid, use the specified
brake fluid.
Install the boot to the groove of the caliper.
Install the pad spring in the caliper.
Install the caliper pin bolt and the slide pin in the
caliper.
Install the brake pad and the hanger pin in the caliper.