DAELIM BESBI SC125 - Service Manual - page 6

1-4

SERVICE INFORMATION

21.  Keep  the  pneumatic  system  interior  or  the  engine 

interior from the infiltration of dust.

22. Install  the  gasket  mounted  in  the  contact  surface  of

each  case  of  the  engine  while  removing  gasket

material completely. Remove damaged contact surface

by wiping with the oil stone equally.

19. Install the oil seal so that the manufacturer marked

surface  directs  outer  surface.(direction  not  covered

with oil)

Pay attention not to bend or damage the lip

Apply the grease to the lip

20. Connect  the  tube  until  the  tube  fully  inserted  in  the

joint. Install the clip if it is supplied. Replace the tube

having slacked end.

23. Pay  attention  not  to  bend  the  cable  excessively.

Transformed or damaged cable may cause malfunction

or damage.

24. Install the boots with the installing groove by inserting

the boots into the groove.

’