DAELIM BESBI SC125 - Service Manual - Service Information
7-1
7. LH. CRANKCASE COVER/KICK STARTER
/CONTINUOUSLY VARIABLE TRANSMISSION
SERVICE INFORMATION
GENERAL SAFETY
Do not allow oil to contact the drive belt or the pulley face. The transmission rate of driving force is reduced with oil
contact.
Do not operate starter motor while the LH. crank case cover is removed.
NOTE
Take precautions not to apply the grease oil to the movable drive face or weight roller.
SPECIFICATIONS
SERVICE INFORMATION
7-1
TROUBLE SHOOTING
7-1
LH. CRANKCASE COVER
7-2
KICK STARTER
7-3
ITEM
STANDARD
SERVICE LIMIT
MOVABLE DRIVE FACE BUSHING INNER DIAMETER
24.01-24.05mm
24.06mm
DRIVE FACE BOSS OUTER DIAMETER
23.960-23.974mm
23.94mm
DRIVE BELT WIDTH
20.0mm
19.0mm
WEIGHT ROLLER OUTER DIAMETER
18.0-18.10mm
17.9mm
CLUTCH OUTER INNER DIAMETER
125.0-125.2mm
120.50mm
DRIVEN FACE SPRING PLAY
97.85mm
163.7mm
DRIVEN FACE OUTER DIAMETER
33.965-33.985mm
33.94mm
DRIVEN FACE INNER DIAMETER
34.000-34.025mm
34.06mm
TROUBLE SHOOTING
Engine starts but motorcycle does not work.
Drive belt worn.
Ramp plate damaged.
Clutch shoe worn or damaged.
Movable driven face spring cut.
Engine stops, or the vehicle runs suddenly,
after starting.
Clutch shoe spring cut.
Vehicle unable to run at the maximum speed,
or lack of output
Drive belt worn.
Defective movable driven face spring.
Weight roller worn.
Pulley face contaminated.
DRIVE BELT
7-6
MOVABLE DRIVE FACE
7-8
DRIVEN PULLEY
7-11