DAELIM BESBI SC125 - Service Manual - page 76
Check the following;
-Movable driven face for damage or excessive wear.
-Guide pin groove for damage or deformation.
Replace damaged or worn parts as necessary.
Measure the I.D. of the movable driven face;
replace if the service limit is exceeded.
SERVICE LIMIT : 34.06 mm
Check the driven face for damage or excessive wear;
replace as necessary
Measure the O.D. of the driven face;
replace if the service limit is exceeded.
SERVICE LIMIT : 34.06 mm
DRIVEN FACE BEARING REPLACEMENT
Remove the inner bearing.
NOTE
If the driven face has an oil seal at inner bearing side,
remove the oil seal first.
If a ball bearing is used on the inside, remove the
snap ring first then remove the bearing.
Remove the snap ring then drive out the outer bearing
toward the inner bearing side.
Drive a new outer bearing into place with the sealed
end toward the outside. Install the snap ring securely.
NOTE
Apply the specified amount of specified grease as
shown.
GREASE APPLICATION : 9.0-9.5 g
Install in a new inner bearing.
NOTE
Install the bearing with the sealed side facing out.
Install the needle bearing using a hydraulic press.
Install the ball bearing by driving it in or using a
hydraulic press.
Install the snap ring into the groove in the driven face.
Install a new oil seal with the lip toward the bearing (if
required).
TOOLS : BEARING DRIVER ATTACHMENT
DRIVE PILOT
7-14
LH. CRANKCASE COVER/KICK STARTER/CONTINUOUSLY VARIABLE TRANSMISSION