DAELIM BESBI SC125 - Service Manual - Master Cylinder

14-6

BRAKE SYSTEM

INSTALLATION

Install the frontcaliper between the front fork and front

axle.

Tighten the caliper fixing bolts to the speciped torgue.

TORQUE VALUE : 3.0 kgf m

Install  the  brake  hose  to  the  caliper  body  with  the  2

new oil bolt washer and oil bolt.

Tighten the oil bolt to the specified torgue.

TORQUE VALUE: 3.4 kgf m

Fill the brake fluid, and bleed air. 

(

14-2 )

MASTER CYLINDER

REMOVAL

Handle cover. 

Drain the brake fluid.

Disconnect the front brake switch wire.

Brake tube bolt.

Master cylinder holder bolt.

Master cylinder .

CAUTION

Brake fluid causes damage to the painted, plastic or

rubber parts. Do not spill fluid on these parts.

If  contaminated,  gently  wipe  off  the  fluid  with  a

piece  of  cloth  or  wash  in  water.  Close  hose  joints

properly to prevent leakage of brake fluid.

Clean  the  disassembled  parts  with  brake  fluid,  and

use  compressed  air  to  verify  each  passage  is  not

clogged.

Do  not  allow  the  disassembled  parts  to  be

contaminated by waste material or dust.

DISASSEMBLY

Remove the  front stop switches.

Remove the boot, cir clip from the master cylinder.

TOOL : SNAP RING PLIERS