DAELIM BESBI SC125 - Service Manual - page 69
DRIVE BELT INSPECTION
Check the drive belt for cracks, pry separation and
wear; replace as necessary.
Measure the width of the drive belt as shown.
Replace the belt if the service limit is exceeded.
SERVICE LIMIT : 19.0mm
NOTE
Use only a genuine DAELIM replacement drive belt.
Do not get oil or grease on the drive belt or pulley
faces. Clean off any grease or oil before reinstalling.
DRIVE BELT INSTALLATION
Install the driven pulley sub assembly on the drive
shaft.
Turn the pulley clockwise and spread the faces apart
while installing the drive belt.
Remove the pulley assembly once with the drive belt
installed.
Put the drive belt on the movable drive face and
remove it.
NOTE
Hold the movable drive faces not to rotate back
again, untill the drive pulley installed completely on
the drive shaft.
7-7
LH. CRANKCASE COVER/KICK STARTER/CONTINUOUSLY VARIABLE TRANSMISSION