DAELIM BESBI SC125 - Service Manual - Rh. Crankcase Cover

8-4

A.C GENERATOR / STARTER CLUTCH

A.C GENERATOR INSTALLTION

Install the stator to the RH. crankcase cover.

Clean the tapered portion of the crankshaft.

Clean the inside part of the flywheel.

Check  the  woodruff  key,  install  the  flywheel  by

aligning the groove with the woodruff key.

Temporarily install the flywheel nut, hold the flywheel

with the universal holder, and tighten the flywheel nut

with the specified torque.

TORQUE VALUE : 5.0 - 6.0 kgf m

TOOL : UNIVERSAL HOLDER

If the universal holder cannot be used, remove the LH.

crankcase cover and hold the drive face with the drive

face holder.

TORQUE VALUE : 0.8 - 1.2 kgf m

TOOL : DRIVE FACE HOLDER

Install the cooling fan .

Connect the A.C.G wiring coupler and connector to the

wire harness, and install the wiring with the clamp.

Install the muffer.

RH. CRANKCASE COVER

REMOVAL

Remove the following parts.

EX. muffler

Cooling fan cover

Cooling fan 

A.C Generator 

Loosen the crankcase cover setting bolt.

Remove the RH. crank case cover.