Hollis Explorer User Manual - page 29
| 21
DATA LOGGING
EXPLORER has a sophisticated data logging system that not only records
all the units’ sensors (depth, time, PO
2
; etc.) but also records any alarms
and error messages. This information can be retrieved through the data
download.
Users can obtain dive download software from http://hollis.com/support.
asp.
STATUS SCREEN
The EXPLORER has two levels of detailed information available to the diver.
The primary method is via the STATUS screen. There is an additional set
of STATUS screens in service mode, described in the PART 3 Section 6 of
this chapter.
The STATUS screen shows as soon as the EXPLORER is turned on (Fig.
3.1).
In addition, Status screens can be viewed at any point in the dive by press-
ing any button and selecting STAT from the pop-up menu using a short
push of the right button.
Once in the STATUS screen, a short press of the left or right button scrolls
through the information options. These are:
a. PO
2
(average of the 3 sensors)
b. CO
2
sensor
c. HP gas
d. Battery life
e. No Decompression Limit (NDL)
f. Decompression Information
g. Filter (CO
2
scrubber)
h. CNS
i. A general Warnings Window (the ACTION Panel) detailing any alarm in
progress. This mostly displays ‘SYSTEM OK’ or ‘DO PREDIVE as in the
above example unless there is another fault to report.
Fig. 3.1
3
.1