Hollis Explorer User Manual - page 40
32 |
DEFAULT GAS (FIG. 3.14)
Set this to your analyzed dive gas. During the Pre-dive checks, if EXPLOR-
ER analyzes a different gas, it will alarm and ask you to recheck the anal-
ysis. For further detail on the proper use of this function, see the following
section "Bailout and Gas Configuration."
HP PAIRING
To pair the HP transmitter, first press SEARCH. Any transmitters within
range of the LSS will be displayed. Once the system finds the transmitter,
press PAIR. The word PAIRED will appear (Fig. 3.15).
! WARNINGS: The transmitter ID is written on the transmitter at-
tached to the first stage in your EXPLORER (Fig. 3.16). Confirm this
is the correct transmitter before proceeding.
!
NOTE: The HP transmitter MUST have pressure applied to it to
activate and be seen by the system. If the regulator is not pressur-
ized the the transmitter will be off and not sending a signal.
Fig. 3.14
Fig. 3.15
Fig. 3.16
SERVICE MODE
Service Mode is used by Explorer service technicians performing diag-
nostics. The settings are off/on. The default setting is off.