Kathrein MSK 130 Instructions For Use Manual - Operating The Signal Meter
Operating the Signal Meter
18 of 100
12
Operating the Signal Meter
12.1
Turning the Device on and off
Turn on the signal meter.
► Press
ON/OFF HOME
.
➯ The meter turns on and is ready for operation within seconds.
Turning off the Signal Meter
► Press
ON/OFF HOME
for 2 seconds.
➯ The meter turns off within seconds.
12.2
Locking the Keyboard and Touch Screen
Locking the Keyboard and Touch Screen
► Press
VOL CONFIG
for 5 seconds.
➯ The keyboard and the touch screen are locked.
Unlocking the Keyboard and Touch Screen
► Press
ON/OFF HOME
.
➯ The keyboard and the touch screen are unlocked.
12.3
Resetting the Device
✔ The meter does not respond.
► Press
ON/OFF HOME
.
➯ A reset is being carried out. The meter restarts automatically.
12.4
Updating Firmware and Channel Plans
You can find information about the firmware and channel plans update performed via the
S.M.A.R.T. Software in the S.M.A.R.T. Software manual at
www.kathrein.com
▶
Solutions
▶
Satellite Reception
▶
Products
▶
Measuring Instruments
▶
Signal Meters
▶ product page
of your signal meter model
▶
Manuals
.
12.5
Resetting the Device to Factory Settings
The signal meter is delivered with a standard configuration (factory setting) for the system
and plan/measurement parameters. To reset the meter to factory settings:
1. Turn the meter off.
2. Turn the meter on and immediately after this, press
VOL CONFIG
for 10 seconds.
➯ When you turn the meter on again, a red square appears in the bottom right corner.
The meter is restored to factory settings.