Kathrein MSK 130 Instructions For Use Manual - Special Functions
Special Functions
78 of 100
► Press
START
to begin the measurement.
➯ The meter tunes the first setting parameter for each one of the selected plans and
displays the signal strength and noise margin values:
20.1.3
DiSEqC Motor
This function allows the user to control motorised satellite antennas using DiSEqC
TM
com-
mands. The control can be done using either the spectrum analyser (
SPECTRUM
) or the
SAT measurement interface (
MEASURE
) . The meter provides the information about the
current azimuth value and the corresponding signal frequency.
► To activate the motor, press
START
in the
DiSEqc MOTOR
menu.
➯ In the top bar it is possible to activate the motor and move it to the west or east. To
do so:
1. Under
ACTION
, select the
MOVE
setting.
2. Under
DIREC
(direction), move the motor to the east by selecting
EAST
and to the
west by selecting
WEST
.
It is also possible to move the motor to a saved position. To do so:
► Under
ACTION
, select the
GO TO
setting and select a saved position under
POSIT
.
Once the command has been determined, press
APPLY
to execute the requested action: