Kathrein MSK 130 Instructions For Use Manual - Changing Basic Parameters
23 of 100
13
Changing Basic Parameters
In the volume menu, you can change the following
settings of the signal meter:
●
VOLUME
●
BRIGHTNESS
●
VIDEO OUT
(Video output)
●
VIDEO IN
(Video
input)
●
IMAGE FORMAT
●
ASI IN
●
RF IN
●
LTE FILTER
(only display)
●
BATTERY SAVING
(power
saving mode)
●
CONFIGURATION MENU
13.1
Changing Volume
1. Press
VOL CONFIG
to open the volume menu.
➯ The volume menu opens.
1. Press the navigation wheel.
➯ The parameter
VOLUME
is active (marked in orange).
2. Press the navigation wheel to go to the volume value.
➯ The volume value is active (marked in orange).
3. Rotate the navigation wheel to change the volume value.
4. Press the navigation wheel to save the selection.
➯ The volume value is saved. The parameter
VOLUME
is active (marked in orange).
13.2
Changing Brightness
1. Press
VOL CONFIG
to open the volume menu.
➯ The volume menu opens.
2. Press the navigation wheel.
➯ The parameter
VOLUME
is active (marked in orange).
3. Rotate the navigation wheel to select
BRIGHTNESS
.
➯ The parameter
BRIGHTNESS
is active (marked in orange).
4. Press the navigation wheel to select the brightness value.
➯ The brightness value is active (marked in orange).
5. Rotate the navigation wheel to change the brightness value.