Kathrein MSK 130 Instructions For Use Manual - 16.1
41 of 100
16
Measuring SAT, TV, CATV and Optical Signals
16.1
General Information
16.1.1
Selecting Signal Type
1. Press
VOL CONFIG
to open the main menu.
➯ The main menu is shown and the menu item SATis active (the symbol is larger).
2. Rotate the navigation wheel or select between
SAT
,
TV
,
CATV
and
OPTIC
by tapping
the symbols on the touch screen.
Tip
You can switch between
SAT
,
TV
and
CATV
measurements both using the
main menu on the touch screen and directly using the push buttons.
16.1.2
Activating and Deactivating Full Screen Mode
✔ A programme is shown during a SAT, TV, CATV or optical measurement.
Activating Full Screen Mode
► Tap the video or go to it using the navigation wheel and press it.
➯ The programme is shown in the full screen mode. The audio and video decoding
information are displayed at the bottom of the screen.
Deactivating Full Screen Mode
✔ A programme is shown in the full screen mode.
► Tap the video or press the navigation wheel.
➯ The full screen mode is deactivated.
16.1.3
Selecting the Sound Mode
► In the full screen mode, tap
CHANGE AUDIO
on the screen to switch between MPEG-
2 and DOLBY AC3 audio.