Panasonic AJ-D400P Service Manual - 3. Option Menu Screen.
3. Option Menu Screen.
Press SHIFT and PAGE simultaneously, then set Menu switch to SET sides for open the Option menu. (Only Option
menu displayed)
How to change the setting item, how to select the item, how to Page up and down, which are exactly same method
as User and Engineer menu.
OPTION MENU
ENG SECURITY
:
OFF
TONE MODE
:
NORMAL
METER SELECT
:
CH1
VF DISPLAY
:
NORMAL
TC OUT
:
TCG
TCG SET
:
RESET
BER SELECT
:
SMPTE
BATT WARNING
:
ON
ITEM
RANGE
PRESET
REMARK
ENG SECURITY
ON/OFF
OFF
OFF
: Engineer, Service and Design menu
can be opened.
ON
: Engineer, Service and Design menu
can not open. But turn Power SW to
OFF under the CAM/BAR SW set BAR
side and then AWB/ABB SW set to
ABB side. And POWER SW to ON
under the above condition, then all
menus can be open.
TONE MODE
NORMAL/ALL
NORMAL
NORMAL
: The TEST TONE signal is output
when the CAM/BAR switch is set
to BAR and the AUDIO IN switch
CH1 is set to FRONT.
ALL
: The TEST TONE signal is output
when the CAM/BAR switch is set
to BAR.
METER SELECT
CH1/BOTH
CH1
CH1
: Audio LEVEL METER which is
displayed on the View Finder is
displayed only CH1
BOTH
: It displayed both CH1 and Ch2.
VF DISPLAY
NORMAL/
SPECIAL
NORMAL
NORMAL
: Status always displayed
SPECIAL
: Status displayed only MODE
CHECK SW set to ON.
TC OUT
TCG, TCG/TCR
TCG
TCG
: TCG signal always output
TCG/TCR
: TCR signal output on V-V mode
and TCG signal output on E-E
mode.
TCG SET
RESET/HOLD
RESET
TCG operation selection when TCG SET
®
power OFF
®
power ON
®
REC is selected.
HOLD
: The fact that TCG SET has been
selected is stored in the memory
when the power is switched off, and
regeneration is not performed.
RESET
: Regeneration is performed without
storing the fact that TCG SET has
been selected in the memory when
the power is switched off.
BAR SELECT
SMPTE/SPLIT
SMPTE
SMPTE
: SMPTE color bar.
SPLIT
: SPLIT color bar
BATT WARNING
ON/OFF
ON
ON
: When the unit becomes BATT NEAR
END condition, ALARM and TALLY
function can be operated.
OFF
: When the unit becomes BATT NEAR
END condition, ALARM and TALLY
function can be operated.