Panasonic AJ-D400P Service Manual - 10-15. Tension Arm Unit
Other manuals for AJ-D400P:
Operating Instructions Manual, Operating Instructions Manual, Operating Instructions Manual
Manual is about: DVCPRO Series Camera Recorder
of
867
10-15. Tension Arm Unit
Replacement
(Removal)
1. Remove the Cassette Cover and Left Side Panel.
2. Remove the Cassette Up Unit.
3. Remove
the
Cut Washer (A) and pick up the
Tension Regi Spring Then remove the Tension
Arm Unit as shown in Figure 10-15-1.
(Installation)
1. Install the new Tension Arm Unit according to the
opposite procedures to removing.
2. After installing, Tension Arm Adjustment should
be performed as follows.
Fig. 10-15-1 Removal of Tension Arm Unit
Tension Arm Adjustment Flowchart
START
1-6. TENSION OFFSET ADJUSTMENT
1-9. TENSION SPRING ADJUSTMENT
1-8. PLAYBACK VOLTAGE ADJUSTMENT
1-7. NEUTRAL POSITION ADJUSTMENT
END
1-8. REV VOLTAGE CONFIRMATION
1-10. REV TENSION CONFIRMATION
NG
NG
OK