Panasonic AJ-D400P Service Manual - 9. Audio Lcd
9. Audio LCD
9-1. Initial Setting
Menu Setting
1. Open the operation panel.
2. Pressing [SHIFT], [
→
] and [
←
] buttons, set MENU
switch to SET position.
3. Set as follows:
PAGE : MAIN FUNCTION
PHANTOM FRONT
: OFF
PHANTOM CH1
: OFF
PHANTOM CH2
: OFF
PAGE : FUNCTION 4/5
FRONT MIC
: -60dB
REAR MIC CH1
: -60dB
REAR MIC CH2
: -60dB
LINE CH1/CH2
: (NTSC) +4dB
: (PAL) 0dB
STEREO/MONO
: STEREO
MIC FILTER CH1
: OFF
MIC FILTER CH2
: OFF
EMPHASIS
: OFF
PAGE : FUNCTION 5/5
AUDIO OUT SEL
: CH1
LIMITER
: OFF
TEST SIGNAL
: OFF
4. After setting turn the menu OFF.
1. Set the SW4701 on Audio LCD board as shown in
figure.
9-2. Playback Level Adjustment
BOARD Audio LCD
SPEC.
(CH 1/CH 2) -20dBu ± 0.2dB
(AUDIO OUT) (NTSC) 4dBu ± 0.2dB
(PAL) 0dBu ± 0.2dB
TEST
Multi Connector CH1/CH2 (12P)
AUDIO OUT (XLR-3P) (12P)
ADJUST VR301 (CH1), VR401 (CH2), VR701
MODE
PLAY
TAPE
(NTSC) VFM3580KM (No.1:0 ~ 14min)
(PAL) VFM3680KM (No.1:0 ~ 10min)
M.EQ
Audio Precision, VFK1210
VTVM, SHAN-C12TCA
SW Setting
AUDIO IN CH1
: REAR, LINE
AUDIO IN CH2
: REAR, LINE
AUDIO SELECT
: MANUAL
1. Connect multi connector with Audio Precision using
VFK1210.
2. Adjust the VR301 (CH 1) so that the levels of CH 1
(12pin multi connector) is within specification.
3. Adjust the VR401 (CH 2) so that the levels of CH 2
(12pin multi connector) is within specification.
4. Adjust the VR701 so that the level of AUDIO OUT
(XLR at Rear Jack) is within specification.
1. When using VTVM, connect multi connector with
VTVM with SHAN-C12TCA.
(Red : CH1, Black : CH2)
2. Follow the same procedure as
Precision>.
1
2
3
4
5
6
1-NOT USED
2-ON
3-ON
4-OFF
5-ON
6-OFF
O
N
SW4701