Panasonic AJ-D400P Service Manual - 10-4. Loading Motor Unit

10-4. Loading Motor Unit

  Replacement

(Removal)

1.  Remove the Cassette Cover and Left Side Panel..

2.  Remove the Cassette Up Unit.

3. Disconnect the connector P612 on Servo

P.C.Board as shown in Figure 10-3-1.

4.  Remove the Pinch Solenoid Unit (Refer to item

10-9).

5.  Remove the Pinch Solenoid Lever. (Refer to item

10-5).

6. Unscrew 

the screw (B) to remove the Emergency

Shaft as shown in Figure 10-4-1.

7. Unscrew 

the 

2 screws (C) to remove the Loading

Motor Neutral Unit as shown in Figure 10-4-1.

8. Unscrew 

the 

2 screws (D) to remove the Loading

Motor Unit as shown in Figure 10-4-1.

Fig. 10-4-1    Removal of Loading Motor Unit

(Installation)

1.  Install the new Loading Motor Unit to Loading

Motor Neutral Unit and tighten 2 screws (D).

2.  Install the Loading Motor Neutral Unit and tighten

the 2 screws (C) so that the pin of Mode SW Unit

matches groove position of main Cam Gear.

3.  Install the Emergency Shaft and tighten the screw

(B).

4.  Install the Pinch Solenoid Unit. After installing,

Pinch Solenoid Position adjustment is required.

(Refer to item 1-2 of Section 3).

10-5. Pinch Arm Unit Replacement

(Removal)

1.  Remove the Cassette Cover and Left Side Panel.

2.  Remove the Cassette Up Unit.

3. Disconnect 

the 

connector P610 on the Servo

P.C.Board as shown in Figure 10-3-1.

4.  Remove the Pinch Solenoid Unit (Refer to item

10-9, and pull up the Pinch Solenoid Lever as

shown in Figure 10-5-1.

5. Remove 

the 

cut washer (A) to remove the Pinch

Solenoid Lever as shown in Figure 10-5-1.

6. Remove 

the 

cut washer (B) to remove the Pinch

Arm Unit as shown in Figure 10-5-1.

(Installation)

1.  Install the new Pinch Arm Unit according to the

opposite procedures to removing. Pinch Solenoid

Position Adjustment is required. (Refer to item 1-2

of Section 3.)

Fig. 10-5-1    Removal of Pinch Arm Unit