Panasonic AJ-D400P Service Manual - Power Supply

29 (E)

Power Supply

Using an AC Power Supply (When using the AJ-B75 AC Adaptor)

1

Connect the unit’s EXT DC IN socket with the DC OUT connector of the AJ-B75 AC

adaptor.

2

Set the AC adaptor’s power to ON.

3

Set the unit’s power switch to ON.

|

Notes

{

¡

When using an external power supply other than the AJ-B75 AC adaptor, check the pin signal

of the EXT DC IN socket.

¡

When both a battery pack and AC adaptor are connected, power is supplied from the AC

adaptor.

¡

When using an AC adaptor, the AC adaptor’s power must be set to ON before the unit’s POW-

ER switch is set to ON. If this sequence is reversed, the AC adaptor’s output voltage will rise

slowly and may cause the unit to malfunction.

DC IN Connector

Pin No.

Signal

1

GND

2, 3

——

4

o

12 V

1

2

3

4