Panasonic AJ-D400P Service Manual - 2. Design Menu Screen.
2. Design Menu Screen.
Press SHIFT , UP ,DOWN and PAGE button on the Right Side Panel simultaneously, then set the MENU switch to
SET position for open the Design menu.
How to change the setting on each item, how to select the item, how to Page up and down, which are exactly same
method as User and Engineer menu. Design menu has 3 kinds of menu screens. And basically Design menu allows
service personal to service this model. Adjustment procedures give a detail of how to use.
[ DESIGN MENU SCREEN ]
DESIGN
H – F COMP
:
ON
MENU ALL INIT.
Y/C TIMING
:
1
SCH
:
4
DEFECT MODE
:
ON
(STATUS)
:
OFF
NOTE: Please be carefully press UP or DOWN button by mistake, when select the item “MENU ALL INIT” . Then
reset all data on all menus except value of FLARE and GAMMA.
ITEM
RANGE
PRESET
REMARK
H-F.COMP
ON/OFF
ON
It compensates for the input signal high-
pass frequency component.
MENU ALL INIT.
—
—
Reset all data on all menu (refer to above
sentence). Also reset OPERATION, DRUM
and THEREADING.
LUMADLY
0-3
0
Y signal is delayed against chroma signal.
(Only playback mode)
SCH
0-7
4
SCH adjustment.
DEFECT MODE
ON/OFF
ON
Select the blemish correction mode.
(STATUS)
ON/OFF
—
Display the status of the blemish
correction.
ON
: Corrected some blemish.
OFF : Not corrected the blemish.